The editor of the electric heating film manufacturer Xiaobian introduces the matters needing attention when using electric heating film :
1: On the floor of the far-infrared electric heating board, do not make fixed decoration or install legless furniture as much as possible. (If there is no legged furniture, consider letting it out.) Prevent local heat dissipation, and do not place it on it for a long time when the temperature is high. Quilts, cushions and the like, otherwise, the temperature under the cushions will overlap, gather heat, generate high temperatures, and damage the membrane and the floor.
2: It is strictly forbidden to lay flame-retardant objects on the heating area of the electric heating plate
3: It is strictly forbidden to nail nails on the floor tiles of the already installed electric heating board heating system
4: When laying (cutting) the floor or floor tile on the hot plate, keep it clean. Do not leave debris, sharp wood chips, nails and other things on the hot plate to avoid damaging the hot plate.
5: Turn off the floor heating or low temperature setting when you are out or the room is empty.
6: It is recommended to choose a brand floor for laying the floor, the thickness is preferably about 0.8, too thick, heat transfer is not good, does not save energy, brand environmental protection indicators are relatively high, so you do not need to worry about harmful gas problems. If you find a strange smell, you should power off and stop in time Use, find out the reason promptly and accurately, and deal with it in time to ensure safe use.
7: It is recommended to set the temperature below 35 degrees for normal use. It should be started from low temperature for the first time to use it for a long time or if it has not been used for a long time. After running at a low temperature of 15-20 degrees for a period of time, it is adjusted to the ideal set temperature.
8: The ground must be covered with a thermal insulation layer. In the northern cold regions (or the ground floor), you can consider increasing the thickness of the thermal insulation layer. This effect will be better.
9: Each room should be equipped with a thermostat.The thermostat should be set on the inner wall which is easy to operate.It should not be placed in a place where it is blocked or cold wall and direct sunlight.
10: The temperature controller should be selected for accurate temperature control, the control area should be larger than the area of the electric heating plate, and the contacts should be pasted on the back of the film. Black strips are hot.
11: It is strictly forbidden to place objects that are not conducive to heat dissipation at the contact points of the thermostat, otherwise the temperature control may be inaccurate, and the temperature of the entire electric heating plate will be unbalanced. The temperature has been reached to the set temperature (such as 30`C), other areas of the film have not actually reached the set temperature of 30`C.
12: Thin-layer technology should be used for laying floor tiles. Mortar cement should be about 3-4CM. Mortar moisture should not be more than electric heating boards should be placed in plastic bags.
13. Do not soak with sweat.
14. If the current strip (copper sheet) on the hot plate is damaged (stepped on or broken off), it will cause fire, so you should pay special attention to this part during transportation and installation.
15. It is forbidden to use the energy cloth directly on the surface of the electric heating plate when using it in the steaming room, or use it on the bottom of the leg.